Planning application
26/0048/TPO
Street Record Alice Templer Close Exeter
Proposal
T9 - Copper Beech Suggested works: Remove major hazardous deadwood T22, T23, T24 - Red Horse Chestnut Suggested works: Fell all to ground level Rationale: T22 and T23 have shown long term signs of disease and disfunction and have now reached a point where the risk has outweighed amenity value. T24 exhibits structural disfunction, removal of this tree along with its companion trees will allow for a comprehensive replanting project. T25 - Cedar Suggested works: Remove major hazardous deadwood
As published by the council, reference 26/0048/TPO
Timeline
Dates from the published record
-
12 Jan 2026
Received by Exeter
-
20 Apr 2026
Decision issued: Split Decision
-
26 Jul 2026
Added to PlanIndex
After the decision
The process from here
The council has decided this application; the published outcome sits in the record above and the decision notice on the council portal carries the detail, including any conditions.
If permission was granted, work must normally begin within three years of the decision. If it was refused, the applicant can appeal within the statutory time limit or submit a revised scheme.
About trees applications
How this application type works
Tree applications cover work to protected trees: those under a tree preservation order need consent for pruning or felling, and trees in a conservation area need six weeks written notice before work starts. The council assesses the amenity value of the tree and can refuse consent, approve it with conditions, or in conservation areas make a preservation order in response.
Nearby applications
Within 500 metres
-
25/1402/TPO Split decision
Gras Lawn Exeter EX2 4SA
G1: T7 - Black Poplar. Pollard at 8-9 metres height T8 - Black Poplar. Remove broken branch & Pollard at 8-9 metres height T9 - Black Poplar. Remove broken branch T12 - Black Poplar. Reduce 4x low limbs overhanging footpath by circa 5m, maximum diameter of cuts 200mm T15 - Black Poplar. Pollard at 8-9 metres height T19 - Black Poplar. Reduce low limb by circa 5m, Maximum diameter of cuts 200mm T20 - Black Poplar. Pollard at 8-9 metres height T22 - Black Poplar. Pollard at 8-9 metres height T28 - Black Poplar. Pollard at 8-9 metres height T31 - Black Poplar. Fell T36 - Black Poplar. Pollard at 8-9 metres height T37 - Black Poplar. Pollard at 8-9 metres height T42 - Black Poplar. Pollard at 8-9 metres height T44 - Black Poplar. Pollard at 8-9 metres height T46 - Black Poplar. Pollard at 8-9 metres height G2: T53 - Black Poplar. Reduce to approximately 18m height. Maximum diameter of cuts approximately 250mm & reduce crown spread to maximum 4m radius. Maximum diameter of cuts approximately 200mm T58 - Black Poplar. Remove one low limb overhanging Barrack Road back to source T61 - Black Poplar. Reduce to approximately 18m height. Maximum diameter of cuts approximately 250mm & reduce crown spread to maximum 4m radius. Maximum diameter of cuts approximately 200mm T69 - Black Poplar. Reduce to approximately 18m height. Maximum diameter of cuts approximately 250mm & reduce crown spread to maximum 4m radius. Maximum diameter of cuts approximately 200mm T73 - Black Poplar. Reduce to approximately 18m height. Maximum diameter of cuts approximately 250mm & reduce crown spread to maximum 4m radius. Maximum diameter of cuts approximately 200mm T78 - Black Poplar. Reduce to approximately 18m height. Maximum diameter of cuts approximately 250mm & reduce crown spread to maximum 4m radius. Maximum diameter of cuts approximately 200mm T81 - Black Poplar. Remove two lowest limbs overhanging Barrack Road back to source G3: T101 - Black Poplar. Remove major deadwood
-
24/0727/FUL Granted
11 Masterson Street Exeter EX2 5GR
The design and installation of an air source heat pump system. The design and installation of solar panel and batteries Modules and Strings Battery Storage (ESS) 7 x 430w ALL BLACK 430w ALL BLACK TIER 1 Panel 430Watts 1 Total Strings. Voc for strings (NOT SPECIFIED). Isc for strings = (NOT SPECIFIED) Inverters Manufacturer(s): Sunsynk Inverter(s): 1 x SUNSYNK-3.6K-SG01/03LP1 Total rating: 3.6kW Max AC Current: %AC Current%A Battery Storage (ESS) 1 x SunSynk Sept 2023 - SunSynk 5.32 5.32 Total kWh
-
26/0845/TPO Granted
Footpath Adjacent To Gras Lawn Gras Lawn Exeter EX2 4SA
T21 - Poplar, reduce low southern branch as identified in supplied photo, by 5m. 175mm diameter of cut. This low limb is nearly in contact with the streetlamp and once the limb reduction works on the adjacent tree (T19) take place in September this limb will be left exposed and the risk of failure will be extremely high.
-
25/1392/FUL Granted
9 Masterson Street Exeter EX2 5GR
Single storey rear extension
-
25/1087/TPO Granted
28 Fleming Way Exeter EX2 4SE
Poplar NT3 This is a tree growing on adjacent land thought to belong to Exeter City Council, the tree overhangs 28 Curie Mews. Specification - Reduce the lowest branch over the north eastern aspect by 3.5m with a 100mm maximum cut diameter, not cutting beyond the boundary Reason for works - This branch has a potential point of decay 1m distal to its junction which may indicate some weakness. The aforementioned branch is also heavily weighted towards the end and it is hyperextended, it looks to have sagged under the load, separating from the general crown profile. It overhangs the garden and trampoline.
-
23/0054/FUL Granted
1 Masterson Street Exeter Devon EX2 5GR
Alterations to garage to create additional accommodation.
Other trees applications
In Exeter
-
26/1122/CAT Awaiting decision
Collingwood Mews Bicton Place Exeter EX1 2PG
T1 - Lawson cypress, abutting and pressing on the side boundary wall: Fell
-
26/1112/CAT Awaiting decision
Homedale Health 34 Denmark Road Exeter EX1 1SE
T1 Yew reduce canopy by approximately 1m and reduce disproportionately overgrown westerly limb by approximately 2m in order to re balance tree. T2 Pittosporum reduce by approximately 1m for maintenance.
-
26/1116/CAT Awaiting decision
10 Magdalen Road Exeter EX2 4SY
T1 - Eucalyptus - Reduce away from property (no. 10 Magdalen Road) allowing a clearance of approximately 1.5m - 2m. Reduce away from neighbouring property (no. 12 Magdalen Road ) allowing a clearance of approximately 1.5 - 2m. Reduce lower branch towards road on Northwest aspect by 1.5 -2m. Crown raise lowest limb in neighbouring property by approx 1m -1.5m. Reason for works: The proposed works are intended to provide appropriate clearance from the neighbouring properties (Nos. 10 and 12) and the adjacent road, reducing the likelihood of branches coming into contact with the buildings during periods of high winds or continued growth. The crown reduction and selective crown raising will also allow increased natural light to reach the neighbouring properties while retaining the tree?s overall form, health and amenity value. The works represent a balanced approach to ongoing tree management and will help minimise the potential for future damage to nearby structures.
-
26/1113/CAT Awaiting decision
40 Alphington Road Exeter EX2 8HS
T001 Elder - A full crown reduction of approximately 1.0-1.5 metres to reduce overall crown dimensions while maintaining a balanced and natural form. T002 Acer - Reduce and reshape the Acer crown by up to 0.5-1.0m on selected branch extremities to maintain a balanced natural form, undertake a light crown thin (approximately 10-15%) to remove congested and crossing branches, and carry out a minor crown lift where required to provide clearance beneath the canopy
-
26/0574/TPO Granted
Block H Birks Halls New North Road Exeter EX4 4GE
The yew tree in question is showing signs of asymmetric crown formation. After previous limb failure causing a structural imbalance to the remaining crown. My proposal for the future vigour of this tree is to Install a dynamic cobra bracing system to support the imbalance of the lower structural limbs forming a strong three way triangulation of support for the lateral growth that has become very prone to wind through. Please see photo (Yew Reduction Points) for bracing points highlighted in blue. Selective thinning of the whole crown by removing internal growth with a maximum cut size of 60mm diameter 1.5m length by removing multiple smaller limbs I believe this will be more beneficial to the trees structure, and limit the amount of large wounds left by the thinning works. Allowing for better wind distribution through the remaining crown hopefully eliminating future wind through. by leaving the larger structural limbs intact for the future longevity of the structural integrity. please see photo (Yew Reduction Points) with cut points highlighted in red for chosen thinning points throughout the crown Remove failed limb back to the branch collar. The failed limb supported by lower crown hazard beam fracturing of the timber 150mm diameter 2.5m length this will be the largest of the limbs to be removed through suggested works. red dotted line on attached photo hard to see the hazard beam on the photo (Yew Reduction Points) Selective reduction of the height maximum of 1m in length 40mm cut size to the crown on selected limbs again highlighted in red so that again the risk of wind through will be reduced.