Planning application
Pennyford House, Rotherfield Peppard
Works: Trees
Decided. The decision notice on the council portal carries the outcome in full, including any conditions.
Proposal
T25 - Locust tree - at rear of image - reduce crown by up to 2.5m. T46 - Mature Oak - remove deadwood. Crown thin and deadwood. T23 - Ash - fell - poor specimen. T24 - Ash - reduce height by up to 2.5m. Remove - two small Holly saplings underneath the Ash in the photo. Tree 47 - Mature Copper Beech - raise canopy by up to 2.5m. Crown thin and remove deadwood. Tree 21 - Lime - raise canopy by removing main branches reaching into neighbours garden. Remove lower branch reaching over studio.
As published by the council, reference P17/S5117/TPO
Application record
- Reference
- P17/S5117/TPO
- Type
- Works to TPO
- Status
- Under Consideration
- Decision
- Application is not yet decided
- Received
- 9 Jun 2017
- Validated
- 9 Jun 2017
Site history
Applications at this address on the South Oxfordshire register
This site has had 3 applications since 2016: 2 approved, 0 refused.
-
P17/S5118/TPO Granted
Pennyford House, Rotherfield Peppard
Reduction in height by approximately 4 ft, plus trimming of 28 Lawson Cypress trees, each approx 20 + feet high, each with a TPO. These trees shade all of our south facing garden in winter.
-
P16/S4965/TPO Granted
Pennyford House, Rotherfield Peppard
T1- Silver birch- remove dead branches from lower drive side T2- Larch- remove dead branches from lower, plus tip off branch entering into the canopy of silver birch T3- Multi Stem Hazel- Reduce to 4 trunks by removing central trunk that crosses over others and causes excessive rubbing, along with dead branches within canopy T4- Immature oak- remove lower branch from wall side along with vertical branch as shown T6- Hawthorn- Thin out canopy by removing crossing branches T7- Hazel- thin out canopy by removing crossing trunks 3x at base T8- Hazel - thin out canopy by removing crossing trunks as base and thinner trunks/whips , remove holly behind? T9- Prunus- remove lower branch from house side and remove all dead wood from lower branches and main canopy T12- Metaseqoia - remove - fell depending on plans for end of garden T13-14- Hawthorns- Thin out canopy by removing crossing branches and shape , remove away from prunus nigra T20-Horse Chestnut- Remove two small branches back to main trunk T21- Lime - raise canopy by removing main branches reacing into neighbours garden, remove lower branch T22- Larch - Remove all dead wood at top of tree - reduce crown height , tree has bad lean and possibility to be felled T23-ASh - remove all dead wood and remove lower misshapen branches T24- Ash- reduce height and take away from power line, remove two holly saplings T25- Locust tree- remove deadwood T28- beech- remove lower branches reaching towards highway, raise canopy T26- Horsechestnut- raise crown height by removing glower x8 branches - deadwood T27- Ash - Remove branch that reaches out into copper beech , remove all lower small branches T29-41- Beechs - raise canopys but removing lower branches along with branches reaching towards and over the highway T40- Beech - remove and reduce crown by removing misshapen branch at top of tree and crossing branches , remove lower branches T42-45- all larch- raise canopy by removing lower branches , along with branches reaching toward and over highway on one, remove all deadwood from canopy T47- Mature copper beech- raise canopy by removing lower branch ends, thin canopy by removing any crossing and misshapen branches , remove deadwood
Timeline
Dates from the published record
-
9 Jun 2017
Received by South Oxfordshire
-
23 Aug 2026
Added to PlanIndex
After the decision
South Oxfordshire has decided this application; the outcome above is the register's own wording and the decision notice on the council portal carries the detail. More in our guide to what happens after a planning decision.
About tree works applications
Applications for works to trees cover protected trees: consent under a tree preservation order, or six weeks notice for trees in a conservation area. More in our guide to planning application types.
Other tree works applications
In South Oxfordshire
-
P26/S4235/TCA Decided
Thorpe Farm House Thorpe Street Aston Upthorpe Didcot OX11 9EQ
T1 - Copper Beech - Reduce branches by approximately 2 metres focusing mainly on lateral branches rather than the top. Lift canopy to provide statutory clearance over the road and clear from service cables. T2 - Tulip Tree - Reduce by approximately 3 metres to restore balance within the crown due to previous limb failure leaving the tree unbalanced. T3 - Horse Chestnut - Reduce by approximately 3 to 4 metres, leaving a natural flowing crown outline and remove major deadwood. T4 - To fell and remove 1 x Yew tree and install eco plugs to prevent re-growth.
-
P26/S4236/TPO Granted
1 Sherwood Gardens Henley-on-thames RG9 1QJ
T1 Copper Beech. Low canopy over road and footpath. To raise canopy to statutory clearances, (5.2m over road, 2.5m over footpath). To remove deadwood greater than 60mm over road and footpath, for safety purposes, minimising any chance for larger falling deadwood in windy conditions.
-
P26/S4118/TPO Decided
Johnson Matthey Technology Centre, Blount’s Court Road, Sonning Common RG4 9NH
Carry out all recommended works as listed within the accompanying tree survey document dated 24/08/26
-
P26/S4579/TCA Decided
St Nicholas House 90 High Street Wallingford OX10 0BW
Magnolia Tree - 1.5m reduce and height and lateral spread to previous pruning points
-
P26/S4354/TPO Granted
Henley College Deanfield Avenue Henley-on-thames RG9 1UH
Ash (T2 of TPO 09/2019) - Reduce back crown over single storey block D4 by a maximum of 4m at its widest point (work mainly relates to over extended limbs over roof). Reduce back low branches over the roof to create 3m clearance. Cutback branches from front of the adjacent building (D6) to create 2-3m clearance. To help balance the crown, reduce remaining crown by approx. 2m. To avoid altering the balance of the tree as a whole, the crown of the tree should be reduced in proportion to its original shape. All pruning cuts must be made at branch junctions, leaving sufficient live growth to maintain or enhance crown form.