Planning application
Hernes Oak, 60 Lower Icknield Way, Chinnor
Works: Trees
Permission granted. Work must normally begin within three years of the decision or the permission lapses.
Proposal
T15 - Willow - Crown reduction of 4-5m, width reduction of 3m, to avoid further branches falling. T15 Willow Spec: S1 Reduce crown height by approx 4-5m, Evenly reduce lateral spread by approx 3m Reason: R1 Sound arboricultural management Reason: R4 To address potential hazard
As published by the council, reference P17/S4967/TPO
Application record
- Reference
- P17/S4967/TPO
- Type
- Works to TPO
- Status
- Decision Made
- Decision
- Granted As published: Consent TPO works
- Received
- 20 Sep 2017
- Validated
- 20 Sep 2017
- Decided
- 6 Oct 2017
Site history
Applications at this address on the South Oxfordshire register
This site has had 2 applications since 2016: 2 approved, 0 refused.
-
P16/S4828/TPO Granted
Hernes Oak, 60 Lower Icknield Way, Chinnor
T1- TPO( T15) - Willow- remove lower growth to raise the crown to a minimum of 5 metres clearance over the drive space, its causing problems to the owners of 7 the hernes oak through falling leaves and bird droppings on to their cars when parked on the drive below, the tree has been pruned on this side of the crown to alleviate these problems in the past. T15 Willow Spec: S7 Lift crown to a height of 5m above ground level, over drive and removing branch tips only Reason: R1 Sound arboricultural management Reason: R2 To ensure future compatibility with site, surroundings and usage
Timeline
Dates from the published record
-
20 Sep 2017
Received by South Oxfordshire
-
6 Oct 2017
Decision issued: Consent TPO works
-
15 Aug 2026
Added to PlanIndex
What this grant of permission means
South Oxfordshire granted permission on 6 October 2017, subject to any conditions on the decision notice. Work must normally begin within three years or the permission lapses. More in our guide to what happens after a planning decision.
About tree works applications
Applications for works to trees cover protected trees: consent under a tree preservation order, or six weeks notice for trees in a conservation area. More in our guide to planning application types.
Other tree works applications
In South Oxfordshire
-
P26/S4235/TCA Decided
Thorpe Farm House Thorpe Street Aston Upthorpe Didcot OX11 9EQ
T1 - Copper Beech - Reduce branches by approximately 2 metres focusing mainly on lateral branches rather than the top. Lift canopy to provide statutory clearance over the road and clear from service cables. T2 - Tulip Tree - Reduce by approximately 3 metres to restore balance within the crown due to previous limb failure leaving the tree unbalanced. T3 - Horse Chestnut - Reduce by approximately 3 to 4 metres, leaving a natural flowing crown outline and remove major deadwood. T4 - To fell and remove 1 x Yew tree and install eco plugs to prevent re-growth.
-
P26/S4236/TPO Granted
1 Sherwood Gardens Henley-on-thames RG9 1QJ
T1 Copper Beech. Low canopy over road and footpath. To raise canopy to statutory clearances, (5.2m over road, 2.5m over footpath). To remove deadwood greater than 60mm over road and footpath, for safety purposes, minimising any chance for larger falling deadwood in windy conditions.
-
P26/S4118/TPO Decided
Johnson Matthey Technology Centre, Blount’s Court Road, Sonning Common RG4 9NH
Carry out all recommended works as listed within the accompanying tree survey document dated 24/08/26
-
P26/S4579/TCA Decided
St Nicholas House 90 High Street Wallingford OX10 0BW
Magnolia Tree - 1.5m reduce and height and lateral spread to previous pruning points
-
P26/S4354/TPO Granted
Henley College Deanfield Avenue Henley-on-thames RG9 1UH
Ash (T2 of TPO 09/2019) - Reduce back crown over single storey block D4 by a maximum of 4m at its widest point (work mainly relates to over extended limbs over roof). Reduce back low branches over the roof to create 3m clearance. Cutback branches from front of the adjacent building (D6) to create 2-3m clearance. To help balance the crown, reduce remaining crown by approx. 2m. To avoid altering the balance of the tree as a whole, the crown of the tree should be reduced in proportion to its original shape. All pruning cuts must be made at branch junctions, leaving sufficient live growth to maintain or enhance crown form.