Planning application
25/1410/CAT
Church Of The Holy Cross 17 Station Road Topsham EX3 0EE
Proposal
Sketch plan T002- Eucalyptus- Fell T003- Elm x5- Fell stems G005- English Elm and Holly- Fell elm and fell holly down T006- Horse chestnut- Maintain minimum 1m clearance from building crown lift all lower branches remove waste. Small branches only no cuts over 3 inches to be included in the crown lifting T007- Common Ash- Crown raise for 3m clearance over carpark and garden back to fence line. T9- Yew- Cut to ground and chip up stump removed T10- Hazel- Reduce to 6 foot and chip brash T11- Hazel- Reduce to 6 foot and chip brash T12- Holly - Reduce to 12 foot, Trim back face of holly T13- Yew- Crown lift to up to 3 metres T14- Hazel- cut to ground T15- Laurel - Reduce to 8 foot remove all waste. Cut single hazel to ground. Trim back road side face of laurel including privet T16- Olive tree - Crown Reduction - Reducing the height and spread of the tree by up to 0.5 metres back to pruning points. T16- Bay- Reduce to 8 foot and chip waste trim face T17 - Birch- Crown Lift to provide 8 feet clearance from ground level Birch
As published by the council, reference 25/1410/CAT
Timeline
Dates from the published record
-
9 Oct 2025
Received by Exeter
-
6 Nov 2025
Decision issued: Permitted
-
26 Jul 2026
Added to PlanIndex
What a grant of permission means
The process from here
Permission has been granted, usually subject to conditions listed on the decision notice, some of which must be discharged before work starts. The decision notice on the council portal sets out exactly what was approved.
Work must normally begin within three years of the decision or the permission lapses. Neighbours cannot appeal a grant; challenging one means judicial review of how the decision was made, within tight time limits.
About trees applications
How this application type works
Tree applications cover work to protected trees: those under a tree preservation order need consent for pruning or felling, and trees in a conservation area need six weeks written notice before work starts. The council assesses the amenity value of the tree and can refuse consent, approve it with conditions, or in conservation areas make a preservation order in response.
Nearby applications
Within 500 metres
-
26/0571/VOC Granted
The Lodge Grove Hill Topsham EX3 0EG
Application Reference Number: 24/0632/FUL Date of Decision: 27/08/2024 Variation of condition 2. Minor amendments to include the addition of a window and a change of wall cladding to match the roof.
-
26/0570/LBC Granted
The Lodge Grove Hill Topsham EX3 0EG
Proposed demolition of garden shed and construction of garden office and store. Revision of listed building consent approval ref. 24/0633/LBC
-
25/1322/PDPV Granted
4 Elm Grove Road Topsham Exeter EX3 0BW
Installation of 13 PV panels on the flat roof of a single storey extension on southeast elevation.
-
26/0862/FUL Awaiting decision
Park And Ride Tappers Close Topsham
Installation of 2 parcel lockers
-
24/0966/FUL Granted
1 Elm Grove Road Topsham Exeter EX3 0EQ
Single storey shed in front garden
-
26/0328/FUL Refused
15 Parkfield Road Topsham EX3 0DR
New second storey to existing single storey extension to dwelling.
Other trees applications
In Exeter
-
26/1122/CAT Awaiting decision
Collingwood Mews Bicton Place Exeter EX1 2PG
T1 - Lawson cypress, abutting and pressing on the side boundary wall: Fell
-
26/1112/CAT Awaiting decision
Homedale Health 34 Denmark Road Exeter EX1 1SE
T1 Yew reduce canopy by approximately 1m and reduce disproportionately overgrown westerly limb by approximately 2m in order to re balance tree. T2 Pittosporum reduce by approximately 1m for maintenance.
-
26/1116/CAT Awaiting decision
10 Magdalen Road Exeter EX2 4SY
T1 - Eucalyptus - Reduce away from property (no. 10 Magdalen Road) allowing a clearance of approximately 1.5m - 2m. Reduce away from neighbouring property (no. 12 Magdalen Road ) allowing a clearance of approximately 1.5 - 2m. Reduce lower branch towards road on Northwest aspect by 1.5 -2m. Crown raise lowest limb in neighbouring property by approx 1m -1.5m. Reason for works: The proposed works are intended to provide appropriate clearance from the neighbouring properties (Nos. 10 and 12) and the adjacent road, reducing the likelihood of branches coming into contact with the buildings during periods of high winds or continued growth. The crown reduction and selective crown raising will also allow increased natural light to reach the neighbouring properties while retaining the tree?s overall form, health and amenity value. The works represent a balanced approach to ongoing tree management and will help minimise the potential for future damage to nearby structures.
-
26/1113/CAT Awaiting decision
40 Alphington Road Exeter EX2 8HS
T001 Elder - A full crown reduction of approximately 1.0-1.5 metres to reduce overall crown dimensions while maintaining a balanced and natural form. T002 Acer - Reduce and reshape the Acer crown by up to 0.5-1.0m on selected branch extremities to maintain a balanced natural form, undertake a light crown thin (approximately 10-15%) to remove congested and crossing branches, and carry out a minor crown lift where required to provide clearance beneath the canopy
-
26/0574/TPO Granted
Block H Birks Halls New North Road Exeter EX4 4GE
The yew tree in question is showing signs of asymmetric crown formation. After previous limb failure causing a structural imbalance to the remaining crown. My proposal for the future vigour of this tree is to Install a dynamic cobra bracing system to support the imbalance of the lower structural limbs forming a strong three way triangulation of support for the lateral growth that has become very prone to wind through. Please see photo (Yew Reduction Points) for bracing points highlighted in blue. Selective thinning of the whole crown by removing internal growth with a maximum cut size of 60mm diameter 1.5m length by removing multiple smaller limbs I believe this will be more beneficial to the trees structure, and limit the amount of large wounds left by the thinning works. Allowing for better wind distribution through the remaining crown hopefully eliminating future wind through. by leaving the larger structural limbs intact for the future longevity of the structural integrity. please see photo (Yew Reduction Points) with cut points highlighted in red for chosen thinning points throughout the crown Remove failed limb back to the branch collar. The failed limb supported by lower crown hazard beam fracturing of the timber 150mm diameter 2.5m length this will be the largest of the limbs to be removed through suggested works. red dotted line on attached photo hard to see the hazard beam on the photo (Yew Reduction Points) Selective reduction of the height maximum of 1m in length 40mm cut size to the crown on selected limbs again highlighted in red so that again the risk of wind through will be reduced.